Homemade Gadget Power Center

Homemade Gadget Power Center

The Excel file for the homemade gadget power center contains sketches and measurements
and can be used as rough plans if you would like to build your own

GadgetCenter.xls


MDF panels with 1/8" groove already cut Panels with 1/4" end dado cut
   
Cutting the 1/4" slots for the cords Layout for the light switches
   
Front panel with cuts and holes for light
switches.
Light switches installed in front panel with
grounding wire installed.
   
Front panel ready for installation Inside panel with holes for outlets cut
   
Break out the connector tab so that each
side of the outlet can be individually
controlled
Assembled unit.(Ya, I know the instructions take a big leap here, but I forgot to take intermetiate photos)
   
Finished and populated unit with Susan's stuff on the right, and mine on the left, with a little room to grow (I know, but it's too hard to go back in time and take more intermediate photos)
Based on Fluidity css adapted by Dan Delcollo